Winnebago 2014 Sightseer User Manual

SECTION 12 –
MISCELLANEOUS
12-8
FIREPLACE
–If Equipped
Manual Operation
• For flame effect, turn the Power-On/Off
switch ON.
• For low heat, turn Heat Level I switch ON.
• For high heat, turn Heat Level I and II
switches ON.
• For temperature control, rotate Temperature
Adjust dial to preferred setting.
• For dimming, rotate the Dimmer dial to
preferred setting.
Remote Operation
• ON-I/II: Press ON-I/II button once for low
heat output. Press a second time for high heat
output. Press a third time for airflow without
heat.
• TIMER: Press ON-I/II button and select heat
output before setting the timer.
Press Timer button and select preset run time
(.5 hour, 1 hour, 2 hours, or 4 hours) shown on
the Indicator Panel (see following photo).
• FIRE: Press Fire button once to illuminate the
fire indicator (located on Indicator Panel) and
for the charcoal to begin burning. Press again
to diminish flame.
• OFF: Press once to turn Fireplace off.
Indicator Panel
Further Information
Refer to the Fireplace user guide provided in
your InfoCase for complete operating and
maintenance instructions, as well as safety
precautions.
POWER ROOF VENTILATOR
Lounge, Galley, or Bath Area
–If Equipped
The vent dome is raised and lowered using the
Dome Crank knob on the fan.
The turbine fan will start automatically as the
vent is raised, and stop as the vent is lowered.
Fireplace Operation Control
(Located behind front grill)
• DIMMER
DIAL
• POWER-ON/OFF
• HEAT LEVEL I/II
• TEMPERATURE
ADJUST DIAL
• ON-I/II
•TIMER
•FIRE
•OFF
Fireplace Remote Control
(Located inside InfoCase)
Indicator Panel
(Located behind front grill)
• TIMER INDICATORS
• LOW / HIGH INDICATORS
•FIRE
INDICATOR

Winnebago 2014 Sightseer Specifications

General

Brand	Winnebago
Model	2014 Sightseer
Category	Motorhomes
Language	English