SECTION 4 –
APPLIANCES AND SYSTEMS
4-2
• Press the MODE button to select energy
source. There are three settings:
LP (Gas Mode) - Refrigerator will operate on
gas from the propane tank if the main valve is
open and the tank contains gas.
AC (Electric Mode) - Refrigerator will
operate on 120-VAC household current if the
shoreline is connected or the auxiliary
generator is running.
AU (Automatic Mode) - Refrigerator will
automatically start operating on 120-VAC
household current if the shoreline is
connected or the auxiliary generator is
running. If electricity is lost, it will
automatically switch over to LP gas operation
if gas is available.
• Press the TEMP SET button to change
temperature setting from 1 to 9 on display.
Start at the ‘coldest’ setting to ensure coldest
temperature in the freezer compartment, then
adjust warmer as necessary after cold food has
been added.
NOTE: The refrigerator will retain temperature
more efficiently if food is already cold
before placing inside.
Further Information
For further information and operating
cautions, see the refrigerator operating
instructions included in your InfoCase.
ICE MAKER
–If Equipped
Some refrigerators are equipped with an
automatic ice maker system. The ice maker unit
is installed in the freezer compartment of the
refrigerator.
NOTE: A water shut-off valve for the ice maker
is located near the water faucet filter
inside the galley cabinet beneath the
sink.
Further Information
See the refrigerator manufacturer’s operation,
care and maintenance information in your
InfoCase.
REFRIGERATOR SERVICE
ACCESS COMPARTMENT
(Exterior)
The exterior refrigerator service compartment
allows access to the rear of the refrigerator for
inspection, maintenance, and service.
To Open
1. Use a screwdriver or coin to turn the latch
knobs to the vertical position as shown.
2. Remove the door from the opening.
Refrigerator Access Door Latches
•CLOSED
• OPEN
To Next Page
Loading...
Need help?
General
