SECTION 6 –
ELECTRICAL
6-6
ELECTRICAL GENERATOR
–If Equipped
Automatic Power Transfer Switch
Whenever the Generator is started, an
automatic power transfer system automatically
switches the household electrical system to the
Generator approximately 30 seconds after the
Generator is started. The 30 second delay allows
the Generator to start easily without the burden of
electrical loads.
The following label is located near the 120-
volt house circuit breaker panel and at the
Generator to warn you to disconnect specific
electrical connections before servicing the
Generator and storing the coach.
Generator Basic Operation
NOTE: If the GenSet Start or Stop switch is
momentarily pressed, the monitor panel
will automatically try to start or stop the
Generator. It will try 4 times (10 second
crank, 10 second rest).
To Start the Generator
Press and Hold the GenSet Start button until
you hear the Generator running smoothly, then
release.
To Stop the Generator
Press and Hold the GenSet Stop button until
you hear the Generator come to a full stop, then
release.
The GFCI will not completely eliminate
the risk of electrical shock. Infants and
small children may still be affected.
Careless handling of the generator and
electrical components can be fatal.
Never touch electrical leads or appliances
when your hands are wet, or when
standing in water or on wet ground.
Do not attempt to repair the generator
yourself. Service should be performed by
a qualified service center.
Do not plug the power cord into the
generator receptacle while the generator
is running. Electrical shock can cause
personal injury.
Automatic Power Transfer Box
(Located inside or behind
utility compartment)
-Typical installation shown
To Next Page
Loading...
Need help?
General
