Winnebago INTENT User Manual

SECTION 10 -
SLIDEOUT ROOMS AND LEVELING
10-6
NOTE: Always clean away any dirt and debris
from the top of the reservoir before
removing the breather cap to avoid entry
of debris and contamination of hydraulic
oil in the reservoir, which could lead to
pump failure or other problems.
NOTE: Only fill the hydraulic reservoir with the
jacks in the retracted (UP) position.
Adding fluid with the jacks in any other
position will cause fluid to leak through
the breather/fill cap.
Hydraulic Fluid Recommendation
The leveling system is filled from the factory
with Automatic Transmission Fluid (ATF).
DO NOT USE brake fluid or hydraulic jack
oil, which can damage the seals and cause leaks.
Further Information
For replacement fluids, see the manufacturer’s
recommendation in the leveling system operation
manual provided in your InfoCase.
Hydraulic Oil Reservoir
(Located behind driver side front tire)
-Typical View
Breather/Fill Cap

Winnebago INTENT Specifications

General

Engine	7.3L V8
Fuel Type	Gasoline
Category	Class C
Manufacturer	Winnebago
Model	Intent
Horsepower	350 hp
Torque	468 lb-ft
Fuel Capacity	55 gal.
Chassis	Ford