Winnebago INTENT User Manual

9-3
SECTION 9 -
FURNITURE AND SOFTGOODS
To return table to previous configuration,
push table down until you hear a click.
SOFA/BED CONVERSION
–If Equipped
(Typical View – Your motorhome may
differ in appearance)
Sofa to Bed
• Pull strap down to release security latch.
• With the strap pulled down, lift the front edge
of the sofa seat upward.
• Release strap and pull outward from the wall
while gently pushing downward on the
backrest until the cushions lie flat.
• The bed is now ready for use.
Bed to Sofa
• Push the front edge of the sofa seat toward the
wall while lifting upward on the backrest until
the sofa is fully seated against the wall and
security latch “clicks” into locked position.
LOFT BED
–If Equipped
(Typical View – Your motorhome may
differ in appearance)
NOTE: The Power Loft Bed is not intended for
storage and should not be used for
storage.
The Loft Bed is stowed near the cab ceiling as
shown in the following photo.
Loft Bed Operation
1. The park brake must be applied and the
ignition key in the on or run position to
operate the loft bed.
2. Turn the key (located near the monitor panel)
to the “ON” position.
3. Push the BED DOWN switch to lower the
Loft Bed.
4. The bed is now ready for use. To access the
Loft Bed see “Loft Bed Ladder” later in this
section.
Security Latch Strap
Pull strap DOWN to release security latch
-Typical View
WARNING
Keep people away from operating
mechanism and pinch hazard areas
during use. Failure to do so could cause
injury.

Winnebago INTENT Specifications

General

Engine	7.3L V8
Fuel Type	Gasoline
Category	Class C
Manufacturer	Winnebago
Model	Intent
Horsepower	350 hp
Torque	468 lb-ft
Fuel Capacity	55 gal.
Chassis	Ford