SECTION 3
GETTING TO KNOW YOUR MOTOR HOME
3-12
3. Check window operation.
4. Check cabinet and door hinges. Lubricate
with penetrating oil, if necessary.
5. Close all faucets and drain valves that are
open. If necessary, reconnect toilet water line
and close flush valve.
6. Add a few gallons of water to the fresh water
tank and check for leaks especially at junc-
tions. Also make sure all hangers and sup-
ports are securely in place. Sanitize the water
system as outlined under “Disinfecting the
Fresh Water System” in Plumbing Section.
7. Check operation of all faucets to be sure
faucet washers have not hardened during
storage.
8. Check sealing valve in the toilet for proper
operation and lubricate with silicone spray.
9. Add water to the holding tank using the toilet
flush pedal. Check to be sure dump valve
seals tightly.
10. Check around all appliances for obstructions
and ensure that all vent openings are clear.
11. Start refrigerator and check for proper cool-
ing.
12. Clean paneling and counter surfaces.
13. Replace batteries if necessary and check out
electrical system to make sure all lights and
electrical components operate.
14. Check tires for proper cold inflation pres-
sure. See Vehicle Certification Label on side-
wall near driver’s seat.
15. After washing accumulated winter grime
from the vehicle, it is important to carefully
inspect the seams and sealants for separation
or cracks that may have appeared around the
window frames, vents and any other joints.
Re-sealing is quite simple and the material is
quickly and easily applied. Appropriate com-
pounds are available from your dealer. Also
inspect weather seals around doors, etc., and
if necessary, have a dealer replace immedi-
ately.
To Next Page
Loading...
Need help?
General
