11-3
SECTION 11
ENTERTAINMENT
11 - ENTERTAINMENT
Rotating Antenna - Make sure antenna is in
the “UP” position. Pull down on rotating knob
until it disengages ceiling plate and rotate for best
picture and sound on TV set.
Lowering Antenna to Travel Position - Ro-
tate antenna until pointer on rotating knob aligns
with pointer on ceiling plate.
Turn elevating crank (counterclockwise) in
“DOWN” direction until resistance is noted. An-
tenna is now locked in travel position. Turn am-
plifier power switch “OFF”.
TV Antenna Signal Amplifier
NOTE: For coaches without the video control
center option, be sure the TV antenna
amplifier switch is turned OFF while
connected to cable. The antenna amplifi-
er will make the cable TV signal snowy.
To operate amplifier, turn on power switch.
TV jack plates are mounted in various loca-
tions throughout the coach. Some of these wall
plates are not readily visible and may be in one of
the following locations.
• Beneath passenger side overhead cabinet.
• In front overhead TV cabinet, if equipped.
• In the flip-down entertainment tray on the
outside of the coach.
Checking Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the trans-
mitter. Signals may vary from strong to no usable
signal at all. We recommend that the TV system
be checked out in an area known to have good TV
reception.
To check the antenna amplifier, raise the an-
tenna, select a TV channel and rotate the antenna
for best picture. Then turn off the amplifier pow-
er switch. If the antenna amplifier is working
properly, the TV picture will now be degraded
(snowy). When you turn the switch back on, the
picture should again be sharp.
CABLE TV HOOK-UP
The cable television connector is located in
the shoreline cord compartment.
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
Always align directional handle to
“DOWN” position before lowering.
CAUTION
To Next Page
Loading...
Need help?
General
