SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
10-10
4. Crank the ratchet wrench “clockwise” to
retract the slideout room. The tool will extend
nearly a foot out of the bed base at first, but
will be drawn into the bed base as the room is
retracted. This is a slow process that will take
some time and quite a few turns of the wrench.
5. As the slideout room retracts, the bed base will
move away from the gear endshaft, which will
eventually cause the tool to lose contact with
the shaft. When this happens, you must raise
the bed, remove the access cover to access the
gear endshaft, and continue using the wrench
and hex shaft only as shown.
6. See your dealer for service of the slideout
mechanism before using again.
GENERAL SLIDEOUT CARE
• Wipe outer seals occasionally with talc or 303
brand protectant for smooth quiet operation.
• Clean the floors inside before retracting the
room to avoid vinyl flooring scratches or
carpet pile snags.
• See your authorized dealer for regular
maintenance and service of the slideout
mechanism.
LEVELING SYSTEM
–If Equipped
The hydraulic leveling system makes
selecting a parking site easier and faster by
reducing the effect of uneven ground.
Hydraulic jacks raise the affected low corners
of the coach to make leveling “set up” faster and
easier for you.
The hydraulic leveling system control pad is
located on the lower left side of the dash.
See the Leveling System Operator Manual
in your InfoCase for complete operating
instructions. It also contains additional
precautions, technical information, and
instructions for manual operation if a system
failure occurs.
NOTE: When parking at an uneven site, always
park the front of the motor home to the
downhill side. This allows you to level by
raising the front end rather than the rear.
Since only the rear wheels are locked
while in PARK, raising either one or both
of the rear wheels off the ground could
allow the vehicle to roll off the jacks.
Leveling System Control Panel
To Next Page
