Winnebago SightSeer - Energy Management System (EMS)

SECTION 4 –
APPLIANCES AND SYSTEMS
4-10
a specific area of the coach or to route
cool air away from a specific area. If too
many vents are closed, however, it can
cause the air conditioner unit to shut
down, particularly in high humidity
conditions.
Further Information
Refer to the air conditioner manufacturer’s
information in your InfoCase for complete
operating instructions.
ENERGY MANAGEMENT
SYSTEM (EMS)
–If Equipped
The Energy Management System (EMS)
monitors the electrical usage of the appliances
and equipment in the coach and allows you to use
certain high energy appliances, such as the
microwave or washer/dryer, without overloading
the shoreline circuit breaker to prevent nuisance
tripping.
Further Information
Please read the Energy Management System
Owners Guide in your InfoCase for important
information on how this system operates under
several conditions, whether 20-amp, 30-amp, and
50-amp connections, or generator service. In 50-
amp service, the load meter is blank. In all other
conditions, the load meter displays actual current
load.
REAR AIR CONDITIONER
POWER SELECTOR SWITCH
–If Equipped
(models with 2 roof air units and 30-amp
service only)
If you want to run the rear AC unit, you must
switch the Rear A/C Selector switch to the proper
power source.
• If you are using the shoreline, the switch must
be in POWERCORD position.
• If you are using the generator, the switch must
be in GENERATOR position.
The rear air conditioner may not operate
properly if the switch is not in the proper position
for the power source being used.
NOTE: The power cord must be plugged into the
generator receptacle for generator
operation.
EMS Display Panel
(Located on Monitor Panel)
-Typical View