EasyManuals Logo

Winnebago View Profile User Manual

Winnebago View Profile
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
SECTION 7 –
PLUMBING
7-8
Waste Pump
The 12-volt Waste Pump disposes gray
holding tank waste through a small diameter
sewer hose, which is then drained through the
main sewage drain outlet.
NOTE: If Waste Pump stalls, check breaker in
the load center. If problem persists,
remove end cap and manually turn pump
shaft (located on the end of the Waste
Pump) with a screwdriver.
Further Information
For further information and operating
cautions, see the Waste Pump operating
instructions included in your InfoCase.
Dumping Holding Tanks
1. Remove sewage drain hose from front driver
side compartment.
2. Remove dust cap from sewage drain outlet
and connect sewage drain hose. Be sure it is
firmly attached.
3. Place the outlet end of sewage drain hose into
disposal opening.
4. Open the Black Waste Tank Drain valve with
a quick pull and make sure there are no sags in
the hose. Move the hose gently about to
dislodge any waste and ensure complete
drainage. Close the Black Waste Tank Drain
valve as soon as tank is empty.
Waste Pump
(Located behind water service center -
accessible through utility compartment)
-Typical View
Sewage Drain Hose
(Located in front driver side compartment)
-Typical View
Sewage Drain Outlet/Dust Cap
(Located in driver side compartment)
-Typical View

Table of Contents

Other manuals for Winnebago View Profile

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Winnebago View Profile and is the answer not in the manual?

Winnebago View Profile Specifications

General IconGeneral
BrandWinnebago
ModelView Profile
CategoryMotorhomes
LanguageEnglish

Related product manuals