16
820 South Wanamaker Avenue, Ontario, CA 91761 | Tel: 866-294-9244
© 2018 Winplus North America Inc. All Rights Reserved.
Issue Cause Remedy
Cannot Jump Start Wrong clamp
connection
Make sure to clamp the RED jumper cable to
the POSITIVE (+) post on the car battery. And
BLACK jumper cable to NEGATIVE (-) post or
car interior. Refer to Page 7 for details.
30-Second timer
to jump start has
expired.
Jump starter timed out. Disconnect the cables
from the vehicle battery and reconnect.
Low battery status Recharge the unit via USB cable until at least
three solid lights or 51% charge.
LED light on the
clamp box keeps
ashing
Protection circuit is
working
Refer to the status table on the indicator box
or page 9 of the manual.
Spotlight / Lantern is
not working
Low battery Recharge the unit via USB cable.
The unit is
charging
As a safety precaution, the spotlight / lantern
light will not work while the unit is charging.
Please unplug the unit from charging or wait
until the unit nishes charging before using
the light.
No wall adaptor Charge via USB
cable
Plug the USB cable into computer or any USB
2A wall adaptor.
TROUBLESHOOTING:
Have a comment or question? Email us at: customercare@winplususa.com
or visit us online at www.winplus.com
ML-55717_V3
To Previous Page
Loading...
