Winplus JUMP STARTER PRO - Jump Starting

6
To jump start the 12-volt vehicle battery, put the
vehicle in park (neutral if the vehicle has a manual
transmission) and engage the emergency brake.
Locate the battery for the vehicle and follow the
steps listed below.
Jumper cables are color coded, RED for
POSITIVE (+) and BLACK for NEGATIVE (-).
DO NOT mix up the cables or allow the metal
ends to touch each other as this may damage the battery,
charging system and/or electronics on a vehicle.
1. Press the power button on the Jump Starter once and check
that the power level indicator is 3 solid lights (51%) or higher.
2. Take the BLUE end of the
jumper cable and plug it into the
power bank jump start socket
which is located underneath the
black cover.
JUMP STARTING:
a) Press the ash button once for the
spotlight in front to ash. Press again for the
spotlight and lantern light to ash.
b) Press the hazard light button once to turn
on the hazard light.
LED FLASH MODE / HAZARD LIGHT
Black
Red
Black
Red
b
a
!