Wisper 705 - User Manual

1
Sean Moroney/Emma Pery 5 Sep 2020 E-Bike Rider’s Handbook doc no. 07
Wisper 705 E-bike Rider’s Handbook
Before you start
● You MUST wear an approved cycle helmet when riding your bicycle
● When using any bicycle, it is important that you stay within safe limits; if you
feel as if you are travelling too quickly, you probably are.
● Always test your brakes prior to using the bike and remember the bike will
not stop as quickly in the wet as it would in the dry.
● Do not ride the bike with flat tyres. There is a tyre pump provided with the
E-bike in the pannier
● This E-bike is not designed for offroad use. Please ride on tarmac or even
surfaces only.
Charge baery: This can be done with the baery sll inserted in the bike rack. Or if you don’t
have a power point near where the bike is stored you can use the key to unlock and slide the
baery out to charge indoors. Pressing and holding down the On buon on top of the baery
reveals the charger level.
The charger and cable will be in the pannier when you collect the e-bike: don’t leave them there
during your week with the e-bike. Please remove them from the pannier and store the charger
and cable in a safe place at home .
The e-bike key locks the baery to the bike and is not needed to operate the bike’s electrical
system.
The baery is connected to the electrical system of the bike automacally when you slide
the baery into the rack. To turn on the bike’s electrical system, press I on the switch located on

Wisper 705 Specifications