Wisper 705 - Lights; The Throttle; Battery Capacity Meter, Riding Style and Effect on Range

3
Sean Moroney/Emma Pery 5 Sep 2020 E-Bike Rider’s Handbook doc no. 07
5. To change from KM to Miles and visa versa: Hold the Power and down arrow for 5 seconds.
If the bike is le for ten minutes without being ridden, the bike will automacally turn off. The
baery capacity indicator bars provide an indicaon of the baery capacity remaining with four
bars indicang the baery is at full capacity. The display also incorporates a diagnosc funcon for
use by Wisper service.
Lights: The LIGHT buon is the on/off buon . If you click the on/off when the bike’s power is on,
the LED headlight and rear light will illuminate. The LCD display will also become back lit.
Click it again to switch off the lights. The power for the lights comes from the bike baery,
but due to the low power consumpon of the LED lights, you will not noceably reduce
your range.
The Throle
The twist grip throle can be found on the le-hand side of the handlebars. PLEASE BE AWARE :
TURNING THIS CAUSES THE BIKE TO LURCH FORWARDS WHEN ASSIST MODE IS NOT SET AT --.
The twist and go throle has two funcons:
i. To power the bike sufficiently to help when walking the bike to a maximum of 4mph.
ii. To increase the power to the motor when on a level road. Your range will decrease if you
use this opon.
Fig 3
Baery capacity meter, riding style and effect on range
The range of the bike (distance covered between recharging of the baery) is greatly influenced by
the level of assist selected, the amount of pedal assistance provided by the rider and the use of the
throle.
If a high level of assist is selected, then the range of the bike will be reduced compared to using a
lower level of assist.
The opmum range is achieved when the rider pedal effort is maximized, and an ideal situaon is
for the rider to aim to match the power being provided by the bike on an equal basis.