Need help?Do you have a question about the WisyCom MCR54 Series and is the answer not in the manual?
Warns about potential hearing damage from high headphone output levels.
Analog monitor audio to 3.5mm jack with volume control.
Configurable analog/AES3 outputs via bottom (MAIN) and top (AUX) connectors.
Configure RX Name, Frequency, Modulation, Compander, and Squelch Mode.
Configure Audio Out, Signal Phase, Calibration Tone, Headphones, and Display.
Set receiver name (12 chars) and select group/channel/frequency.
Select Wideband or Narrowband modulation based on transmitter.
Configure compander systems: ENS, ENR-Wisy, ENC-Wisy, ENR/ENC-1.2.
Set Squelch Mode: Normal, Long Range, OFF, and User-defined.
Set max audio level for analog (-24 to 18 dBu) and digital (-30 dBFS) outputs.
Tune transmitter to receiver frequency via IR interface for synchronization.
Scan for channels by group or manually select frequencies.
Select found channels and synchronize receiver with transmitter.
Select receiver for monitoring and adjust display/LED settings.
Procedure to connect, run Wisycom Manager, and update firmware via USB-C.
To Next Page
General
