Network Addresses Setup
Figure 1: Addresses configuration window
REMEMBER: MRK9xx has a static IP, the IP address set in factory as default is 192.168.10.1/x.
Check on the label on the rear panel
The Network Devices Configuration window is useful to scan the network for available
Wisycom Ethernet devices and to configure it. In a period of some seconds, the software
collect information about all compatible systems on the
network and show a list of them.
At this moment, it is possible to access the IP configuration
window by clicking on the small gray icon on the right ❶.
When the configuration is done, the user can choose which network devices include on the
management with the checkboxes on the left ❷. The list of the enabled devices will be saved
on the configuration file, and will be reused also in the next executions of the software, unless
this configuration is redone in
the future, accessing the form
in File->Addresses on the
menu.
In case of the device doesn’t
compare during the scan, it is
possible to insert manually the
IP address in the box named
“Address List” (this feature is
available only in the latest
versions of WM).
Insert the list of the IP address
and push the button Add.
To Next Page
Loading...
