1.2. Prerequisites
•
Have the STB ready, connected, and provisioned on the customer backend
•
The Witbox will be configured in DHCP on its "Network" port, it only requires valid Internet access to reach its Hub
Cloud (the Witbox connection only requires an outbound HTTPS connection — a standard & simple Internet access)
2. Hardware setup
2.1. Connect the Witbox to power and network
Perform the following cabling:
1. Connect the Witbox power supply to a power source. As soon as you plug it in, the Witbox automatically powers
itself on.
2. Use the red cable, to connect the Witbox "Network" Ethernet port to your network switch.
To Next Page
Loading...
General