2.2.1. STB with IR remote controls
1. Plug the IR blaster from the "IR" port of the Witbox to the front of the STB (where the IR LED is located). It is
recommended to secure the blaster to the STB thanks to the supplied IR blaster sticker. This also reduces possible IR
leaks.
2.2.2. STB with Bluetooth remote controls
No physical connection is needed, the Witbox will be paired to the STB using Workbench.
2.3. Add STB power control
1. Use the power cord to connect the Power Controller to a power source.
2. Use the blue Ethernet cable to connect the Witbox «Accessory» Ethernet port to the Power Controller.
To Next Page
Loading...
General