19
5. Set prefix code
After setting the local code, The first of three codes flashes. Press CLID ▲or▼ to select
digits and press DEL/SET to save selection. Use the same procedure to continue setting
each digit.
6. Set the ring melodies
After setting the prefix code, Press CLID ▲or▼ to select a melody (1-16) and press DEL/SET to
confirm.
7. Set the ring volume
After setting the ring melodies, press CLID ▲ or ▼ to select ring volume (1-8) and press
DEL/SET to confirm.
8. Set flash time
After setting the ring volume, press CLID ▲or▼to select flash time (100ms, 200ms, 300ms,
400ms, 600ms, 900ms) and press DEL/SET to confirm.
9. Set pause time
After setting the flash time, press CLID ▲or▼ to select pause time (1.2s/2,4s/3.6s) and press
DEL/SET to confirm.
10. Set DTMF or Pulse mode
After setting the pause time, press CLID ▲or▼ to select the mode (DTMF or Pulse), and press
DEL/SET to confirm and complete the whole setting.
11. Pause
When dialing, press the REDIAL button to insert a 3.6s pause time between digits. This function
is used behind a PABX. Insert the PAUSE between the PABX access digit (usually 0 or 9) and the
number to be dialed. Use this function when you want to redial a number or when you store a
number in memory.
12. Store a number in one-touch memory keys M1- M10
Press the STORE key, then enter the telephone number you wish to store using the dial pad,
press M1, the number is now stored under M1. Use the same procedure to continue setting other
one-touch memory keys.
OPERATION N
1. Make a call:
Pick up the handset or press , after receiving dial tone and dial the desired
number.
2. Answer a call:
Pick up the handset or press to answer a call.
3. End a call:
Hang up the handset or press to end the call.
4. Switch talk mode from handset to speakerphone:
Press and then hang up the handset to talk through the speakerphone.
5. Switch talk mode from speakerphone to handset:
Pick up the handset and the talk mode will switch to the handset automatically.
To Next Page
Loading...