Witech WT-3020 - Wall Mounting Instructions; Preparing for Wall Mounting; Securing the Base Unit to the Wall

22
telephone number, you should later be able to
redial the number. If your PABX requires you
to wait for a second dial tone before dialing the
telephone number, press the Pause Button for
a pause between the access digit and
number.
LCD IS DIM.
Adjust the LCD contrast (See Page 18, “set
the contrast”)
CAN’T TRANSFER A CALL TO ANOTHER
PABX EXTENSION.
Check that the flash time is set correctly.
Flash time should be set to 100ms to comply
to RSA Specification. (See Page 19, “set flash
time”)
WALL MOUNTING G
The phone can be wall mounted if user needed, when wall mounting, user has to change the
position of the handset hook guide & fix the base unit on the wall, the steps as below:
1. To change the position of handset hook guide
a. Remove the handset hook guide by sliding upwards.
b. Rotate 180 degrees and re-insert. The handset hood guide will ready for wall mounting
(Figure 1).
2. Fix the base unit on your original wall mount, or you may follow the instructions as below of no
wall mount on the wall
a. Choose a location close to telephone wall jack.
b. Draw mark 8.3cm vertically apart on the wall (Figure 2).
c. To check the location of mark before drilling to make sure no any wiring or hidden pipes
behind the wall.
d. Drill and then insert screws into the wall and leaving the heads around 2 millimeters out of
the wall, adjusting it if necessary (Figure 3).
e. Fix the base unit on the wall.