21
Wizard CMC Model 8000 RC Hardware and Software Getting Started Manual
CMC 8000RC/Frameshop 20-71034-1 GettingStartedManual8000RCFrameShop
http://info.wizardint.com/KB/default.aspx#pageid=getting_started_manual_8000_rc 04/05/19
5. The new template is displayed.
Go to Cut Preview
6. Click Cut to go to the Cut Preview
screen.
Outside Cut
7. You can toggle the Outside Cut on or o by clicking the Cut Outside
toggle.
Put Matboard on the CMC
8. Make sure there are two layers
of disposable backing matboard of
adequate size underneath the matboard to
be cut.
9. This design is cut from the back. Place
the matboard face down onto the CMC
(facing away from the operator). Make
sure the matboard nestles tightly under the
horizontal clamp and vertical clamp of the
CMC.
Click Cut
10. Click Cut to cut the mat.
11. Because the motors are still engaged, the
CMC will automatically begin to cut.
12. After it has nished cutting, remove the
matboard from the CMC. The second mat has
been cut.
13. Click the “X” button to return to the New Openings screen or Click the “X”
button three times to return to the Main Screen.
To Next Page
Loading...
Need help?
General
