Need help?Do you have a question about the Wizard CMC 9000z and is the answer not in the manual?
Lists the necessary items for operating the CMC.
Provides resources like the Knowledge Base and website for support.
Identifies components of the CMC head assembly with labels.
Displays various types of cartridges available for the CMC.
Shows the Electronic Control Unit (ECU) and air regulator components.
Labels various parts of the CMC machine, including gantry, clamps, and control panel.
Instructions for assembling and positioning the CMC stand or wall mount.
Step-by-step guide for safely removing the CMC from its packaging.
Details on how to remove protective shipping blocks from the gantry.
Procedure to verify the alignment of drive belt marks for proper function.
Step-by-step instructions for mounting the cutting head onto the gantry arm.
Guide on connecting the data cable between the gantry and the ECU.
Instructions for connecting the air lines to the gantry and control panel.
Connects the computer, monitor, and peripherals like the keyboard and mouse.
Steps for physically connecting the Electronic Control Unit (ECU) to the computer and power.
Completes the ECU connection by linking power and data cables to the unit.
Describes the function of the emergency stop button and system power.
Explains how to adjust and fine-tune clamp pressure for different materials.
Instructions for starting a cut or pausing an active cut.
Steps to start the software and create a new mat design.
Setting mat borders, outside dimensions, and selecting templates.
Choosing a pre-defined template from the library for mat design.
Setting layers and selecting cutting cartridges for the design.
Previewing the design and configuring blade depth.
Setting blade depth and configuring software to exclude outer cuts.
Instructions for inserting a new blade into the cutting cartridge.
How to properly position the matboard on the CMC for cutting.
Steps to start the cutting process.
Procedure to align the cutting head when the machine's motors are off.
Setting the head air pressure based on matboard density.
Changing blades and cartridges, and post-cut procedures.
How to create new mat designs and select templates.
Selecting templates and navigating to the cut preview.
Configuring outside cuts and placing matboard for cutting.
Steps to start the cutting process.
How to adjust clamps to cut material without waste.
Adjusting and fine-tuning clamp pressure for different materials.
Utilizing the VPO feature for pressure control.
Setting the head air pressure based on matboard density.
Detailed steps for setting head air pressure for different matboards.
Settings and procedures for cutting extra dense matboard with the 90° cartridge.
Instructions for changing blades in cartridges and pens.
Information on different blades and cartridges.
How to stop a cut and resolve common cutting problems like wavy cuts.
Solutions for blades breaking during the cutting process.
Answers to common user queries about the CMC operation.
A schedule of routine maintenance tasks for the CMC.
Instructions for maintaining the air regulator.
Important safety warnings, disclaimers, and copyright information.
To Next Page
General
