Wizard CMC Model 9000z Hardware and
Software Getting Started Manual
Check Contents
Review equipment upon arrival for shipping damage. Contact Wizard if any damage is noticed. Verify that the
contents shown in the packing slip are received. Please save the packaging.
Equipment Required
The CMC Stand must be assembled rst before unpacking the Wizard™ CMC (Computerized Mat Cutter)
1/4” NPT female tting on main air line, or quick disconnect attachment
Electrical outlet
Air source - You will need an air compressor that supplies between 100psi and 120psi.
Surge protector
Table for the computer/monitor if not using the stand
Where to Find More Information
Knowledge Base
Login to the Knowledge Base with your Customer ID, which can be found on your License Screen (Options >
View License from the FrameShop main screen).
The Knowledge Bases contains a wide assortment of searchable documentation and information which can be
found at:
FrameShop Software Knowledge Base: http://info.wizardint.com/FS40.
9000z Hardware can be found on the Knowledge Base: http://info.wizardint.com/KB.
Website
Check out the Wizard website at www.wizardcutters.com for additional information.
20-34304-1A GettingStartedManual9000zFrameShop
04/05/19
5
Wizard CMC Model 9000z Hardware and Software Getting Started Manual
Wizard™ CMC Model 9000z Hardware and Software Getting Started Guide
To Next Page
Loading...
Need help?
General
