Need help?Do you have a question about the Wizard 8000 RC and is the answer not in the manual?
Verify received equipment and check for shipping damage.
General instructions for setting up the CMC.
Instructions for setting up the CMC stand or wall mount.
Verifying squareness and installing the head onto the gantry.
Connecting the board cable and air lines to the CMC.
Connecting air lines and the air regulator.
Connecting the computer, keyboard, and mouse.
Connecting the Driver Pack/ECU to the computer and power.
Steps to power on the Driver Pack/ECU.
Adjusting the blade depth for cutting different materials.
Detailed steps for aligning the head when motors are disengaged.
Cautions for operator fatigue, alcohol, and hazardous voltages.
Warnings regarding moving parts, sharp blades, and proper operation.
To Next Page
General
