WMF 1100S - Clean the Drip Tray

82
User Manual WMF1100 S
Care | Manual cleaning
7.6.5 Clean the drip tray
Scalding hazard
• The drip tray may contain hot liquids.
• If the drip tray is not properly engaged, such
as after cleaning, there is aburn hazard due
to hot liquids.
> Be careful when moving the drip tray.
> Replace carefully so that no water
accidentally drips down.
> Always make sure the drip tray is seated
correctly.
 Lift up the front of the drip tray slightly and
removeit
 Remove the drip tray grid and clean it with the
cleaning brush
 Clean drip tray thoroughly
 Clean the SteamJet spout and cover thoroughly
with the included cleaning brush
 Rinse the drip tray and the drip grid with clear
drinking water
 Dry the drip tray and the drip tray grid, reassemble
and replace
The underside of the drip tray and the area
around the drip tray sensor must be dry
before it is inserted. The sensor is on the
right, underneath the drip tray. If there is
residual moisture in this area, the message,
“Emptydriptray” appears again.
CAUTION
Follow the Safety chapter
w starting on page 7
IMPORTANT