To Next Page

To Previous Page

Use and operation

1. Fill the jug (4) with the required quantity of milk and then close the lid (1).

2. Now place the jug (4) on the base unit (6).

Caution:

Always put the lid (1) on the gadget ﬁrst before switching it on.

Never remove the lid (1) while the gadget is switched on.

Otherwise, the WMF milk froth DISC (3) may no longer function correctly even

when the lid (1) is replaced.

Note:

preparation can be stopped at any time by pressing the start/stop button (5) or by

removing the jug (4) from the base unit (6).

Allow the appliance to cool down before using again.

The texture and volume of the milk froth depend on the type of milk used

(including fat content, protein content, temperature).

Soft creamy milk froth

Select this program for warm, creamy, ﬁne-pored milk froth. This is particularly

suitable for cappuccino or latte style coffee.

▪ Fill the jug (4) with 100 to 150ml of cold milk.

The jug (4) is marked with the following measures:

100 ml MIN

150 ml MAX

DO NOT overﬁll the jug, otherwise the milk froth will overﬂow and spill over

the appliance.

▪ Place the lid (1) on the jug (4) and push down gently to seal.

▪ Now press the start/stop button (5) repeatedly until the lamp for the

symbol illuminates. After approximately 3 seconds, the appliance starts

automatically, the control lamp for the start/stop button (5) is illuminated.

▪ After the program has ﬁnished, the appliance automatically switches itself off,

the control lamp is no longer illuminated. Lift the lid (1) and skim off the milk

froth separately or pour it out with the rest of the milk.

Firm milk froth

Select this program if you require a warm, ﬁrmer consistency of milk froth. This is

particularly suitable for cappuccino or latte macchiato style coffee.