To Next PageTo Next Page
Need help?Do you have a question about the WNT HDG2 and is the answer not in the manual?
Explains the document's scope and illustrates safety symbols for hazard identification.
Defines intended use, lists technical data, and details foreseeable misapplications and unauthorized modifications.
Covers guidelines for spare parts and highlights inherent residual risks associated with the device.
Specifies operator qualifications, required personal protective equipment, and the product warranty conditions.
Details the device's applications, how to adjust the clamping range, and the clamping/releasing procedures.
Explains the quick-release mechanism, mechanical force generation, and how clamping range is determined.
Guides users on clamping, aligning the vice, and the impact of jaw selection on performance.
Provides instructions for routine cleaning and lubrication of the clamping device to ensure proper operation.
Offers solutions for low clamping force, including cleaning and potential part replacement.
Details troubleshooting steps for when high-pressure tension is achieved too early during operation.
Explains procedures for adjusting the stop pin and setting ring, and removing/installing parts.
Provides step-by-step instructions for removing and installing the clamping device carriage and locking pin.
Presents a detailed assembly drawing with numbered components for reference and identification.
Describes how to install and use the angle drive accessory and methods for achieving an increased clamping range.
Lists specific clamping forces and torques for different models, including measurements for locking pins.
Details testing procedures for angularity and form/position tolerances of the clamping surface.
Provides guidance on the safe and environmentally responsible disposal of the clamping device and its accessories.
General