Wolf-Guard YL-007M2B - Delete Remote Controller; Coding of Defense Zone; Delete Defense Zone; Change Password

7
 Delete Remote Controller
The remote controller can’t control the main unit after it’s deleted
.
In setup state, use keypad to input [21], then input the remote controller
number [1-8], and then press [#] to confirm. The main unit emits a long
beep and the [Signal] indicator flickers once. You will hear a voice
prompt “delete completed”.
Operating method
: [21] Ö [A] Ö [#]
A indicates˖1~8 remote controllers number.
 Coding of Defense Zone
Wireless detectors have to be coded to the main unit in order to trigger it
alarm.
In setup state, use keypad to input [23], input the defense zone number
you want to code [01~99], and then input [#] to confirm. The main unit
emits a long beep and the corresponding defense zone is displayed on the
screen. You will hear a voice prompt “detector coding”. Then trigger a
wireless detector to emit a wireless signal; after receiving the signal, the
main unit makes a long beep, and you will hear “coding completed”, the
[ ] indicator goes out at the same time.
Operating method
: [23] Ö [XX] Ö [#]
XX indicates: 01 ~99 defense zones number
LCD display:
 Delete Defense Zone
The wireless detector can’t control the main unit after it’s deleted
.
In setup state, use keypad to input [24], then input the defense zone
number you want to delete [01~99], and then input [#] to confirm. The
main unit emits a long beep and the defense zone indicator flickers once.
You will hear a voice prompt “delete completed”.
Operating method
: [24] Ö [XX] Ö [#]
XX indicates: 01 ~99 defense zones number
8
 Change Password
1 Change Operation Password
Operation password is the password used to disarm or remote control.
In setup status, use keypad to input [30], then input the 4-digit new
password, and then press [#] to confirm. The main unit will make a long
beep and you will hear a voice prompt “setting completed”.
Operating method
: [30] Ö [XXXX] Ö [#]
XXXX indicates: the new 4-digit password
For example
: change the system password to 1012
Operating method
: [30] Ö [1012] Ö [#]
LCD display:
2 Change Program Password
Program password is the password you should input in order to setup
the system.
In setup status, use keypad to input [31], then input the 4-digit new
password, and then press [#] to confirm. The main unit will make a long
beep and you will hear a voice prompt “setting completed”.
Operating method
: [31] Ö [XXXX] Ö [#]
XXXX indicates: the new 4-digit password
For example
: change the system password to 2846
Operating method
: [31] Ö [2846] Ö [#]
LCD display:
Note˖
˖
the operation password and the programming password can not be set
as the same number.
 Clock Setting
In setup status, use keypad to input [32], then input the last 2 digits [AA]
of the present year, the two digits [BB] of the month, the two digits [CC]