EasyManua.ls Logo

Wolf-Guard YL-007M2B - GSM Signal Checking; Maintenance

Wolf-Guard YL-007M2B
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
previous alarming record; press 8, downturn to check; and press [*#] to
exit checking.
For example
: the 51st defense zone; the 7th alarming; alarming time:
12:00, August 1st, 2008. LCE display
for one second, and then
display the alarming time:
GSM Signal Checking
Before installing the main unit, you should check the signal of the
installing place in order to ensure the unit can perform well. In setup
state, input [81]Ö #, the main unit will make a long beep and display
00+XX (XX indicates the intensity of the signal). And the intensity
should be within the range of 07-31; if it’s less than 07, you should
change place.
For example
: if the signal intensity is 12, it will display as:
Maintenance
System Checking
Although the alarm system is used everyday, periodical maintenance and
test are required to assure that it can run stably, reliably and safely.
Usually thorough test must be performed on the alarm main unit every
three months. You’d better check the detector once a month; if not
permitted by condition, you should check it at least every three months.
Check the main unit:
1. Whether it can arm/disarm normally.
18
2. Whether it can dial the number for alarm normally.
3. Whether it can receive wireless detectors’ signal normally
4. Whether the back-up battery can work normally.
Check the wireless detectors:
1. Trigger wireless detectors to see if system can alarm normally.
2. Check all detectors’ batteries to see if it’s in low voltage.
3. Check whether wireless detectors can send signal to the main unit
normally.
Notes:
Please do not disassemble, repair and alter the products without
permission, or it may cause accidents and faults.
Do not drop this product on the ground or on hard objects, as it may lead
to massive impact to cause faults and damages.
Without approval and consent of relevant authorities, please do not set
“110”, “119” or the alarm phone number of police station for this main
unit.
Technical Parameters
List 1:
Input Voltage DC12V/1A
Standby Current
<55mA
Alarming Current <450mA
Wireless Frequency
315/433MHz, 2262/4.7M
GSM Frequency 900/ 1800/ 1900MHz
Back-up Battery
NI-HI AAA*6 DC7.2V
Siren Volume 110dB

Related product manuals