Wolf 106302 - Maintenance Recommendations

Maintenance
It the
power
cord is
damaged.
it must be
replaced by
the
UKHS.
the
supplier.
Please contact
our technical
department
if
you
require
assistance on 0330 123 0001
Always
lubricate drill bits with suitable oil when
drilling.
This will
prolong
the life of drill bits
and aid
cutting
(metal only).
Caution: Do not use water-based coolant or
any
kind of continuous coolant
pump.
Remove all swan‘ and dust after each
operation.
Spread
oil onto
unplated
sun‘aces
especially
if the
pillar
drill is not
used for
long periods.
Lubricate the
spindle
drive with oil
every
six months.
The
spindle guide
screw should
also be checked
regularly
This
product
does not
contain
any parts
that can be
repaired by
the
consumer.
Please contact our
technical
department
if
you require
assistance on 0330
123 0001
\Vo'F-106302
—
Page
19