Delivery/Handling
Delivery
AHU TE air-handling units are delivered to site as transportable subassemblies.
On receipt of the incoming goods, check the unit or components to ensure no damage
has occurred in transit.
If damage is evident or if there is a suspicion that damage might have occurred, the
recipient must make a note to this effect on the freight papers and have this countersigned
by the carrier.
Notify WOLF immediately of such circumstances.
Always transport the equipment upright.
Exception:Plate-typeheatexchangers(subjecttotypeandsize)andheatwheelheat
exchangersarelaidat(turned90°)fortransportation.
Otherwise the internal components will suffer damage and this can result in malfunctions.
Handle the appliances with slings.
Tall appliances on a small footprint (e.g. RWT) are connected with an increased risk of
tipping over during unloading and handling on site.
This requires additional measures
on site to prevent tipping over (e.g. securing with straps).
If a forklift or rollers are used to move the units, always ensure that the forks or rollers are
located underneath the frame sections at all times, so that weight is never allowed to rest
ontheoorpanels.
With lifting eyes (available on request), use slings at minimum centres L between lifting
eyes. Ensure that the slings are of uniform length.
Always use a crane lifting beam to lift appliances with more than 4 lifting eyes.
On no account may cladding panels be removed in order to lift the device, since the
cladding panels are structurally integrated in the device's bracing system.
No additional loads may be lifted together with the transport unit supplied by Wolf.
Note
Handling
To Next Page
Loading...
