To Next PageTo Next Page
Need help?Do you have a question about the Wolf AHU TE and is the answer not in the manual?
General| Brand | Wolf |
|---|---|
| Model | AHU TE |
| Category | Air Handlers |
| Language | English |
General overview of symbols, safety instructions, and hazards for air-handling units.
Defines proper applications, prohibited uses, and associated liability for units.
Provides a technical overview of the air-handling unit's capabilities.
Guidelines for safe lifting, transport, and positioning of air-handling units.
Specifies minimum clearance needed for installation, operation, and maintenance.
Recommendations for selecting and preparing the final installation site.
Guidance on assembling ventilation units and securing them against tipping.
Ensuring level, horizontal, and load-bearing foundations for units.
Details on securing base frames and using connecting brackets for units.
Integrating base frames into roof sealing and considerations for unit placement.
Steps for disassembling units and sealing components for water tightness.
Instructions for fitting and sealing roof sections on weatherproof AHUW TE units.
Details on small items for assembly and appliance connection brackets.
Procedure for joining units with screws and external connection methods.
Describes different methods for internal appliance connections.
Guidelines for securely connecting and sealing stacked air intake/exhaust air units.
Installation details for fan sections and flexible connections.
Water quality standards, scrubber installation, and siphon setup for drainage.
Instructions for assembling hoods and identifying different unit versions.
Ensuring safe electrical connections and details for EC fan wiring.
Troubleshooting motor issues and residual current circuit breaker requirements.
Wiring configurations for single, two, and three-speed motors.
Procedures for checking fan belt tension, alignment, and motor rotation.
Verifying damper movement, frost stat, and filter monitor settings.
Procedures for commissioning heating, electric, and cooling coils.
Commissioning direct-expansion cooling coils, scrubbers, and humidifiers.
Lubrication of fan bearings and checking vee-belt tension and alignment.
Maintenance for flat belt drives and checking fan impeller vibrations.
Procedures for cleaning heat exchangers, dampers, scrubbers, filters, and charcoal filters.
Measures to protect heat exchangers, steam coils, electric coils, scrubbers, and siphons from frost.
Procedures for shutdown, fire safety measures, and equipment disposal and recycling.
Recommended checklist for hygienic operation and maintenance of air-handling systems.
