Wolf COB-29 - List of Required Parts

5
3062549_201510
3. List of required parts
Maintenance tools included in the COB standard
delivery
We recommend you have
the following as part of your
service kit:
Item Description Part no.
1 Gasket for ue DN 100 86 12 016
2 Ignition electrodes 24 83 647
3 Seal ring for oil/air connection 89 05 738
4 Boiler sensor 27 41 058
6 Ignition cable 24 83 310
Standard delivery up to 12/2009 Standard delivery from 01/2010
The maintenance instructions supplied with the appliance must be observed when carrying out maintenance.
Setting gauge with scraper
Maintenance tool
Cleaning brush
Setting gauge
Cleaning hook
Cleaning brush with
extension for COB-40
Maintenance tool
Maintenance requires the following:
Pos. Description Part no.
1 COB maintenance tools
Cleaning brush
Maintenance tool
Cleaning hook (from 01.2010)
Setting gauge (from 01.2010)
Standard delivery
24 83 520
24 83 394
24 83 916
24 83 879
2 COB-15 maintenance set
Oil nozzle Danfoss 0,30/80°S
89 06 615
89 06 588
2 COB-20 maintenance set
Oil nozzle Danfoss 0,40/80°S LE
89 05 809
89 05 812
2 COB-29 maintenance set
Oil nozzle Danfoss 0,55/80°S LE
89 05 872
89 05 839
2 COB-40 maintenance set
Oil nozzle Danfoss 0,55/80°S LE
Oil nozzle Danfoss 0,65/80°S LE
89 06 625
89 05 839
89 06 619
2.1 Also included in all maintenance sets
Combustion chamber lid seal ring
Silicone grease
Oil lter replacement cartridge 40 μm Siku
Flat gasket for ame tube/ame tube adaptor
with four oval head screws M 4x10
Seal ring for ame tube/ame tube adaptor
(87 x 2.5 mm)
Flame light tube end piece
Cable grommet
89 05 729
86 02 264
24 82 496
89 06 731
89 06 617
28 00 707
39 10 171
3
Replacement granulate for neutralisation COB-15/20/29 24 83 972
3 Replacement granulate for neutralisation COB-40 24 83 974
4 Measuring instrument for BimSch test -
5 Screwdriver -
6 2x SW 16 open-ended spanners -
7 Allen key 4 mm -
8 Allen key 6 mm -
Setting gauge
Maintenance tool
Cleaning hook