Need help?Do you have a question about the Wolf CTEWH30I and is the answer not in the manual?
General| Brand | Wolf |
|---|---|
| Model | CTEWH30I |
| Type | Wall Mount |
| Lighting | LED |
| Finish | Stainless Steel |
| Voltage | 120 V |
| Number of Fan Speeds | 4 |
| Material | Stainless Steel |
| Appliance Category | Ventilation |
| Width | 30 inches |
Provides Wolf Customer Service contact details.
Provides the Wolf Appliance website address.
Instructions for installers to read and save.
Instructions for homeowners to read and keep for reference.
Hoods recommended for Wolf cooktops; warranty and website info.
Placeholder for model number.
Placeholder for serial number.
Follow National Electrical Code and local codes/ordinances.
Hood aspirates air, passes through grease filter, expels outside.
Hood purifies air with grease and charcoal filters, returns clean air.
Instructions for ducted installation of wall and island hoods.
To reduce the risk of fire, use only metal ductwork.
Consult HVAC Engineer; limit duct run length and elbows.
Installation must be by qualified installer or service technician.
Steps for securing the hood mounting brackets to the wall studs.
Adjusting and fixing the telescopic flue support bracket.
Power connection at the hood, including wiring box and connections.
Must follow National Electrical Code regulations and local codes.
Additional wiring for in-line or remote blowers.
Blower connection at hood and in-line/remote blower connection.
Hood must be properly grounded; installation by qualified electrician.
Recirculation kit must be purchased separately.
Installation must be by qualified installer or service technician.
Steps to remove grease filter and install charcoal filter.
Follow steps from page 8 for fixing the hood to the wall.
Attaching air baffle, flange, and flue for recirculating installation.
Follow wiring connections outlined on page 9.
Information on optional accessories available through Wolf dealer.
Installation must be by qualified installer or service technician.
Steps for mounting the metal panel and bracket to the ceiling.
Power connection at the hood, including wiring box and connections.
Hood must be properly grounded; installation by qualified electrician.
Recirculation kit must be purchased separately.
Installation must be by qualified installer or service technician.
Follow steps from page 12 for fixing the hood to the ceiling.
Attaching air baffle, flange, and flue for recirculating installation.
Follow wiring connections outlined on page 13.
Steps to remove grease filters and install charcoal filter.
Information on optional accessories available through Wolf dealer.
Refer to specific installation instructions provided with each blower.
Risk of fire/shock; use only specified Wolf blowers.
Steps for wiring the blower, including electrical box and wire connections.
Note wire colors; ensure blower is OFF before powering hood.
Steps to follow if the hood does not operate properly.
Call a Wolf authorized service center for quality maintenance.
Provides Wolf Customer Service contact details and website.
To Next Page
