EasyManua.ls Logo

Wolf R1 - Page 6

Wolf R1
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3061809_12106
Pump connection WolfboilercircuitandDHWcylinderprimarypumpsarefactory-
ttedwithplugs.Routethecablethroughtheboilerbackcutout.
Inserttheplugintothemarked-uplocationsintheplug-inconnector
strip,andsecurethecableswiththeirstrainrelief.
Installation / Electrical work
Outside temperature
sensor
(accessory)
Jointheon-siteleadoftheoutsidetemperaturesensorwiththe
plugsupplied.Inserttheplugintothemarked-uplocationinthe
plug-inconnectorstrip,andsecuretheleadwithitsstrainrelief.
Route the lead through the boiler back cutout. Fit the outside
temperature sensor to the north or northeast wall, 2 to 2.5m
abovegroundlevel.
DHW sensor
(accessory)
PushtheDHWcylindersensor(accessory)intothecylindersensor
well.Routetheleadthroughtheboilerbackcutout.Inserttheplug
into the marked-up location in the plug-in connector strip, and
securetheleadwithitsstrainrelief.
E1
programmable input
JointhecableofinputE1withtheplugsupplied.Inserttheplug
into the marked-up location in the plug-in connector strip, and
securethecablewithitsstrainrelief.Routethecablethroughthe
boilerbackcutout.
eBUS accessories Remotecontrol,radioclockmodule,radioclockmodulewithoutside
temperature sensor, receiver for wireless outside temperature
sensorandwirelessanalogremotecontrol.
Join the on-site accessory cable with the green plug supplied
(designatedeBUS).Inserttheplugintothemarked-uplocation
intheplug-inconnectorstrip,andsecurethecablewithitsstrain
relief.Routethecablethroughtheboilerbackcutout.
Note:
IfseveraleBUSaccessoriesaretobeconnectedsimultaneously,
connecttheseinparallelattheeBUSterminal.
A1
programmable output
JointhecableofoutputA1totheplugsupplied.Inserttheplug
into the marked-up location in the plug-in connector strip, and
securethecablewithitsstrainrelief.Routethecablethroughthe
boilerbackcutout.

Related product manuals