Need help?Do you have a question about the Wolf R1 and is the answer not in the manual?
General| Brand | Wolf |
|---|---|
| Model | R1 |
| Category | Control Unit |
| Language | English |
Lists relevant EC directives for the control unit's compliance.
Lists relevant DIN and EN standards applicable to the control unit.
Outlines regulations for the installation and commissioning of heating systems.
Defines the intended use and limitations of the Wolf R1 control unit.
Provides critical warnings regarding operation, safety, and potential risks.
Details requirements for maintenance and repair by qualified personnel.
General installation steps and component routing guidelines for the control unit.
Detailed instructions for connecting the unit's power supply correctly.
Explains the function of the ON/OFF switch and the illuminated status indicator ring.
Details the various functions and proper usage of the reset button.
Covers DHW/heating temp selection, winter/summer modes, and their operation.
Explains how to enable and operate the emissions test mode for the system.
Describes the function of the thermometer and the fine-wire fuse.
Details the eBUS connection for data transfer with PC/laptop accessories.
Explains the STB function and anti-seizing pump protection.
Lists and describes various configurable control parameters for the unit.
Configuration of the frost protection limit for the heating system.
Settings for different parallel DHW operation modes.
Setting the maximum domestic hot water temperature.
Setting the burner switching differential for temperature regulation.
Configuration of pump operating modes, including mode 0 and 1.
Settings for pump mode 2, specifically for BSP cylinders.
Setting the run-on time for the boiler circuit pump.
Setting the maximum boiler water temperature limit.
Configuring the duration of the burner cycle block.
Configuring functions for the programmable input E1.
Details the various functions that can be assigned to programmable input E1.
Details the various functions that can be assigned to programmable output A1.
Configuration of central sensor input and burner block settings.
Configuring external burner demand via input E1.
Important notes and considerations for return sensor configuration.
Details the functions that can be assigned to programmable output A1.
Setting the hysteresis for cylinder heating control.
Setting the run-on time for the cylinder primary pump.
Setting the maximum duration for DHW cylinder heating.
Setting the minimum boiler water temperature.
Setting the maximum boiler water temperature.
Configuring the operating modes for the DHW sensor.
Setting boiler excess temperature during cylinder heating.
Configuration for boiler soft start to prevent corrosion.
Setting for raising return temperature in heating systems.
Setting the hysteresis time for burner switching.
Selecting the type of eBUS feed for system communication.
Configuring the 0-5V input for telecontrol system integration.
Performing test functions for control unit outputs.
Procedure to test the functionality of the high limit safety cut-out.
Steps to perform a system reset to factory settings.
Lists and explains the various operating modes of the control unit.
Lists displayable set/actual values on the BM programming module.
Procedure for setting eBUS addresses in cascade configurations.
Details on assigning unique BUS addresses to boilers.
To Next Page