Wolf R1 - Contractor Level Parameters - Operating Modes; Operating Modes Overview

273061809_1210
Contractor level parameters
The operating mode can only be displayed via WOLF control accessories with
eBUS capability. For procedures, check the operating instructions of the relevant
accessories.
Operating mode
(displayontheBM
programmingmodule)
Status HG Explanation Notes
0
Standby
1
Emissiontestmode max.15min.
3
Heatdemand(heatingmode)
5
Heatdemandwithcycleblock
6
Cycleblock seeHG09
7
Frostprotection-heating seeA09
8
Softstart seeHG26
15
Cylindermode forboilers
16
Frostprotection-cylinder < + 5 K
17
Pumprun-on-cylinder seeHG19
20
Parallelcylindermode seeA10
21
Max.cylinderheatingtimeexceeded seeHG20,MI09
22
Sensoroperatingmode2,contactclosed seeHG24
23
Sensoroperatingmode3,contactclosed seeHG24