Wolf R1 - Contractor Level Parameters - Display Values; Set and Actual Values Display

3061809_121028
Contractor level parameters
The temperature (set / actual temperature) can only be displayed via Wolf-control
accessories with eBUS capability. For procedures, check the operating instructions
of the relevant accessories.
Set / actual values
(displayontheBM
programmingmodule)
Display Name
DHW TEMP
Actualcylindertemperature
Setcylindertemperature
OUT TEMP
Outsidetemperature
ES AVERAGE
Averageoutsidetemperature
ES MAX MIN
Maximumoutsidetemperature(0to24h)
Minimumoutsidetemperature(0to24h)
ROOM TEMP
Actualroomtemperature
Setroomtemperature
MODE HC
Operatingmode-heatingcircuit
(sun,moon,standby)
HEADER TEMP
Actualheadertemperature(°C)
Setheadertemperature(°C)
BOILER TEMP
Actualboilerwatertemperature
Setboilerwatertemperature
RETURN
Actualreturntemperature
Status HG
Boilerstatus
BURN RUN H
Burnerhoursrun
BURN START
Boilerburnerstarts