WOLFF MAMBO - Maintenance

13
09/2004 Schleifmaschine MAMBO, Artikel-Nr. 013495 , ab 324 vom 21-09-04Fugenfräse FRÄSMASTER
Speed control
For your own safety start work always at low speed, and then
increase the speed. This is especially important, if the subfloor
condition or the discs used are not well known.
3.1 Introduction
This operating manual should be used to get the most benefit
from your Grinding machine MAMBO. Following these instruc-
tions will both extend the life of your machine and reduce repair
costs.
Please ensure any user of the machine is fully familiar with the
instructions for use before allowing work to start.
3.2 Danger while working with the machine
The Grinding machine MAMBO is designed to the highest
technical standards. Incorrect use can be dangerous!
Use this machine only
Disturbances that could impair safety, have to be eliminated at
once.
3.3 Restriction of use
The Grinding machine MAMBO is exclusively for wet-cleaning
and polishing of resilient and textile floor coverings, and for
grinding and milling pavement and levelling compounds in dry
environments. It should not be used for any other purpose. Wolff
cannot be held responsible for any damage or loss
caused by incorrect use.
3.4 Genuine Spare Parts
Spare parts and accessories are manufactured uniquely for the
Grinding machine MAMBO. It must be emphasized that parts
obtained from unauthorized sources must not be used.
Wolff cannot be held responsible for the performance of or any
damage arising from the use of machines in which genuine spare
parts have not been used.
This is particularly important with milling discs.
4.0 Maintenance
The Grinding machine MAMBO is virtually maintenance-free.
The roller bearings and gear box need not to be lubricated.
Use this machine only
 as instructed in this operating manual
 with the machine in perfect working order.
WOLFF GmbH cannot be held responsible for any
damage or loss caused by incorrect use Correct use
also includes
 to take care of all directions from the operating
manual and
 the execution of maintenance and service.