19
09/2004
Schleifmaschine MAMBO, Artikel-Nr. 013495
, ab 324 vom 21-09-04Fugenfräse FRÄSMASTER
System carbide milling wheel disc with 4 modules, Item-No. 013569:
for removing adhesives, PU- and epoxy-coatings and roughening anhydrite pavements („beating“ action).
Due to the aggressive action, the system milling disc should not be used onto chip board.
Milling disc with star wheel segments Item-No. 016149
Additional to the new System-milling-disc the milling disc with star wheel segments offers high efficiency.
Producing a high effect of dismounting and an aggressive action, this disc is used for removing coatings and
adhesive residues. The result is a rough surface. Comes with 3 star wheel segments.
Cleaning pad discs 400mm, 10mm
For initial cleaning, Item-No. 013543, For cleaning and mounting of gauze
For maintenance, Item-No. 013544, For coarse cleaning and removing soil
For polishing, Item-No. 013545, For polishing, cleaning and wax coating
Super pad discs 400mm, 20mm
For initial cleaning, Item-No. 013546, For cleaning strong soiling
For maintenance, Item-No. 013547, For coarse cleaning and removing soil
For polishing, Item-No. 013334, For polishing, cleaning and wax coating
8.0 Trouble shooting
Trouble Eventual cause Elimination
Machine does not Power supply Have machine
start Disconnected repaired by a qualified
blown fuse electrician,
defective cable or plug resp. change parts
Switch-on lever Safety lever can only be Lower the handle of
cannot be actuated actuated, if handle not vertical the machine
To Next Page
Loading...