Page 5
www.wolfpackequipment.com (419) 302-0033
Maintenance
2.7 After each working day, you should do cleaning and maintenance.
2.8 Remove the mud and dust on the machine, especially the grinding disc. Use an air gun or water gun to flush the
bottom. Do Not flush the electrical parts with the water gun.
2.9 For 6 months of continuous or intermittent use, the gear oil 2Liters must be replaced. Check oil weekly.
3.0 Always check the condition of the grinding head and the grinding disc for damages or wear. When a grinding disc
is replaced, it is better to replace all discs at the same time to ensure the quality of the floor.
3.1 Clean water tank every 5-7 days to avoid sediment build up.
3.2 When the machine is not in use, it can be cleaned and stored in a safe dry place.
Moving the machine
3.3 Insert carry poles, adjust handle to horizontal position, and lift machine as shown below
Changing/Attaching tooling
3.4 Tip over the machine using pedal as shown below
Machine must be OFF, not running and emergency stop button locked, when changing abrasives, accessories, or
performing maintenance. Should it be necessary, pull out the power or plug.
To Next Page
Loading...