WOLSTEAD PRO 10 TRAY DEHYDRATOR OWNER’S MANUAL 7
Setting the timer
1. Press the timer button to adjust the drying time of your food. Then press the
+ or the - button to select the desired drying duration. Please note, the unit cannot
operate for more than 24 hours at a stretch. The timer cannot be set for less than
one hour.
2. At any time you can adjust the temperature by using the temperature button, and
then select + and – buttons.
3. The time in the display window will begin to countdown.
4. The dehydrator will automatically shut off after the set time has ceased. If
dehydration is complete, remove food from the dehydrator. If additional drying time
is needed, follow the preceding steps to continue dehydrating observing that you
don’t go beyond the 24 hour straight usage.
5. At any time, you can adjust the time by using the timer button, + or – buttons.
6. You can stop the dehydrator at any time by pressing the power button.
Adjusting the temperature
1. Press the power button for at least two seconds to turn on the unit which will
light up.
2. Press the temperature button on the control panel to turn on the temperature
adjustment function. Then press the + or the - button to select the desired
temperature. To change the temperature swiftly, hold down the + or - buttons. As
mentioned above, the temperature range for this unit is 30 to 90°C.
3. At any time you can adjust the temperature by using the temperature button, and
then select + and – buttons. Please note that the temperature can not be lower than
30°C or higher than 90°C.
4. You can pause or stop any layer if needed. When you need to increase the
temperature or adjust time, you need to select that layer rst, then set it accordingly.
5. You can stop the dehydrator by pressing the power button at any time.
To Next Page
Loading...