10
8. Insert Proper Adapter into Slot
flip open the Negative Adapter then place appropariate Insert
accordingly (see diagram below), and snap close the adapter tightly
to avoid
jamming when inside the F2D-Super.
Warning:
Using
improper Adapter or Insert
will result cropped
image or
black areas on image.
Negative Adapter
with 110 Insert
110 INSERT
SUPER 8 INSERT
Negative Adapter
with Super 8 Insert
Negative Adapter
Flip open
Negative Adapter
For the best results, use included cleaning brush with felt side
down to wipe dust off the light table gently before each use.
11
U
se fine soft cloth or compressed air (not included) to clean the
film before putting them into the Adapter.
Gentlely feed the film
from the right side of Adapter. Feed negatives or slides with
shiny side up; feed Super 8 film with pereferated holes at
topside, refer to diagrams on page 12.
9. Prepare Film and Feed the Film into Adapter
Insert and push in
Negative or Slide
Adapter until stopped
Insert film Adapter into the right side
slot and push in Adapter from right to
left side; improper direction would
damage F2D-Super.
To Next Page
Loading...
Need help?
General
