Laser Installation
Laser Installation - LT70
2
2-5 97LS97doc062612 Laser Installation
2.2 Laser Installation - LT70
1. Locate the four square mounting holes on the saw head near the bottom of the drive-side
blade housing. Mount the laser/bracket assembly to the saw head using the four carriage
head bolts, flat washers and lock nuts. Place the star lock washers between the laser
bracket and the saw head to ensure proper grounding of the unit.
See Figure 2-5.
2. Remove the drive belt guard.
3. Route the cable from the laser assembly as shown:
See Figure 2-6.
Route the laser cable under the saw head along the brace plate and secure the
cable with the three provided wire clamps. Bolt the wire clamps to the brace plate
with the three M4x16 screws, flat washers and nuts provided.
Connect the red laser cable wire to red accessory wire #25. Connect the black laser
cable wire to the black -12 V DC wire.
Use the two provided wire ties to secure the laser cable.
FIG. 2-5
To Next Page
Loading...