14
Setting Up the Wood Chipper
Step 27: Install the wheel bearing
caps.
Setting Up the Wood Chipper (continued)
Step 28: Fill the engine with 1.16 qtrs.
(37 oz.) of standard motor oil
(10W-30) or AMSOIL 4-Stroke full
synthetic (best choice). Fill the fuel
tank with ethanol free gasoline for
best performance. (10% ethanol is OK,
but not preferred)
Step 30: Remove the belt cover to expose
the drive belts. Check for proper tension,
refer to the decal on the belt cover for
proper tension and maintenance intervals.
Step 29: Both shaft bearings are
factory greased and should NOT be
greased again. Please refer to the
Bearing Lubrication Guide chart for
recommended lubrication intervals.
NOTICE!
WoodMaxx recommends the use of gasoline that does not contain ethanol.
This will prolong the life of the rubber seals in the engine.
To Next Page
Loading...