Woods BH85 - User Manual

Questions and Answers

B
brittanybeanAug 3, 2025
Why is the oil heating up in my Woods BH85 Construction Equipment?
- W
  Whitney JimenezAug 3, 2025
  If the oil in your Woods Construction Equipment is heating up, it could be due to several reasons. First, check if the oil supply is low and fill the reservoir if needed. Another potential cause is contaminated oil; in this case, you should drain the reservoir, change the filter, and refill with clean oil. Also, ensure that the relief valve is set to the correct pressure. Finally, avoid exceeding 540 RPM PTO speed, as the pump may be operating too fast.
G
Gregory TurnerAug 8, 2025
What to do if Woods BH85 Construction Equipment has foaming oil?
- E
  Erin MendezAug 8, 2025
  If you observe foaming oil in your Woods Construction Equipment, there are several possible causes. Begin by checking the oil level and fill the reservoir if it's low. Inspect the suction line for air leaks and tighten the fittings if necessary. Ensure that you are using the correct type of oil; if not, drain the reservoir and refill it with non-foaming oil. Lastly, check for moisture in the oil. If present, maintain the oil temperature below 180° and continue operation to allow the oil to dry out. If foaming persists, replace the oil and purge the system.
S
Samantha WardAug 12, 2025
How to fix a noisy pump caused by cavitation in Woods BH85?
- R
  Ronald DuncanAug 13, 2025
  A noisy pump in your Woods Construction Equipment caused by cavitation can stem from several issues. If the oil is too heavy, change to the proper viscosity. A plugged oil filter can also be the culprit, so replace the filter. Additionally, inspect the suction line for blockages or inadequate size, cleaning it as necessary and verifying its dimensions. Finally, check for any kinks in the suction line, and replace the line if any are found.
M
Megan WaltersAug 18, 2025
How to repair shaft seal leakage in Woods BH85 Construction Equipment?
- J
  Jennifer PerkinsAug 18, 2025
  Shaft seal leakage in your Woods Construction Equipment is likely due to a worn shaft seal. To resolve this, replace the shaft seal.
J
Jennifer ContrerasAug 23, 2025
What to do if boom drops on Woods BH85 Construction Equipment?
- M
  Melanie DuncanAug 23, 2025
  If the boom drops as the dipper or bucket cylinder lever is activated while the boom control is in a raised position on your Woods Construction Equipment, it is likely due to a leaking load check valve. You should clean or replace the check valve assembly.
M
Michael MortonAug 28, 2025
Why is my Woods Construction Equipment operating jerky?
- G
  gholderAug 28, 2025
  Jerky operation in your Woods Construction Equipment can be caused by incorrectly plumbed hydraulic hoses. To fix this, check the hydraulic plumbing schematic and correct the hose routing as needed.