Assembly 29
MAN1298 (4/02/2020)
ASSEMBLY
DEALER SET-UP INSTRUCTIONS
Assembly of this cutter is the responsibility of the
Woods dealer. It should be delivered to the owner com-
pletely assembled, lubricated, and adjusted for normal
cutting conditions.
The cutter is shipped partially assembled, and intended
to be handled in the vertical position. Use appropriate
lifting devices to move into horizontal position for
assembly.
Assembly will be easier if aligned and loosely assem-
bled before tightening hardware. Recommended
torque values for hardware are located in the Bolt
Torque Chart, page 44.
Complete Dealer Check Lists, page 28 when you
have completed the assembly.
Full chain shielding must be installed when
operating in populated areas or other areas where
thrown objects could injure people or damage
property.
• If this machine is not equipped with full chain
shielding, operation must be stopped.
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
condition.
It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
Make sure attachment is properly secured,
adjusted, and in good operating condition.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
Figure 27. Shipping Configuration
1. A-Frame bar
2. Upper mounting hardware
3. Break link
4. Lift arm
5. Break link pivot hardware
6. Shield
7. Tailwheel
8. Rubber belting
9. Tailwheel bracket
2
3
4
9
6
7
5
8
1
To Next Page
Loading...
