EasyManua.ls Logo

Woods TURF BATWING TBW15.40 - User Manual

Woods TURF BATWING TBW15.40
72 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OPERATOR'S MANUALOPERATOR'S MANUAL
(
Rev 9/29/2022
)
MAN1331
TURF BATWING
®
TBW12.40
TBW15.40
TBW17.40

Table of Contents

Questions and Answers

  • B
    Benjamin NixonAug 9, 2025
    Why is my Woods TURF BATWING TBW15.40 Lawn Mower leaving streaks?
    • A
      Ashley CollierAug 9, 2025
      If your Woods Lawn Mower is leaving streaks, it might be due to several reasons. The grass might be too wet, so allow it to dry before mowing. The blades may not be cutting the grass pressed down by the tractor tires; try slowing the tractor's ground speed while keeping the engine at full PTO rpm, cutting lower, and adjusting the tractor tire spacing if possible. Dull blades can also cause this, so sharpen or replace them. Finally, check the blade hardware, as a loose blade can also be the culprit.
  • A
    Adam PorterAug 20, 2025
    What to do if material discharges unevenly from my Woods TURF BATWING TBW15.40?
    • M
      Maria RichardsonAug 20, 2025
      Uneven discharge and bunching of material from your Woods Lawn Mower can be caused by the material being too high or too much of it. Reduce your ground speed while maintaining 540 RPM at the tractor PTO, or make two passes over the material. For the two passes raise the mower for the first pass and lower it for the second pass, cutting at a 90-degree angle to the first pass. Also, raise the rear of the mower high enough to allow for material discharge. Another cause is wet grass; allow the grass to dry before mowing, and slow the ground speed of the tractor while keeping the engine running at full PTO rpm.
  • J
    John McgrathAug 30, 2025
    Why does my Woods Lawn Mower cut lower in the center?
    • S
      Steven PhillipsAug 30, 2025
      If your Woods Lawn Mower is cutting grass lower in the center of the swath than at the edge, this may be because the mower height is lower at the front than at the rear. In this case, adjust the mower height and attitude so that the rear and front are within 1/2 inch of the same height. Another potential cause is a loose blade, so check the blade hardware.

Summary

Specifications

Safety

Safety Rules

Outlines essential safety rules for operation, transport, maintenance, and storage.

Preparation

Operation

Attaching Mower to Tractor

Instructions for connecting the mower to the tractor, including driveline and hitch.

Installation and Removal of Driveline (Tractor PTO)

Details the process for installing and removing the PTO driveline safely.

Cutting Height Adjustment

Explains how to adjust the mower's cutting height using caster wheels.

Wing Offset Adjustment

Pre-Operation Checklist

A checklist for ensuring the mower is ready for operation and all checks are done.

Starting and Stopping Mower

Procedures for safely starting and stopping the mower and tractor PTO.

Removing Mower from Tractor

Owner Service

Blocking Method

Lubrication Information

Details lubrication points, types, and frequencies for mower maintenance.

Belt Servicing

Blade Servicing

Dealer Service

Blade Spindle Repair

Instructions for repairing blade spindles, including disassembly and assembly.

Gearbox Service

Procedures for servicing the mower's gearbox, including removal and repair.

Drive Sheave Installation

Universal Joint Repair

Assembly

Dealer Checklists

Warranty

Woods TURF BATWING TBW15.40 Specifications

General IconGeneral
ModelTURF BATWING TBW15.40
Cutting Width15 feet
Minimum Tractor HP40 hp
Number of Blades6
Hitch TypeClevis
Transport Width93 inches
Deck MaterialSteel

Related product manuals