!
WARNING
Read this entire manual and all other publications pertaining to the work to
be performed before installing, operating, or servicing this equipment.
Practice all plant and safety instructions and precautions. Failure to follow
instructions can cause personal injury and/or property damage.
The engine, turbine, or other type of prime mover should be equipped with
an overspeed (overtemperature, or overpressure, where applicable)
shutdown device(s), that operates totally independently of the prime mover
control device(s) to protect against runaway or damage to the engine,
turbine, or other type of prime mover with possible personal injury or loss
of life should the mechanical-hydraulic governor(s) or electric control(s),
the actuator(s), fuel control(s), the driving mechanism(s), the linkage(s), or
the controlled device(s) fail.
!
CAUTION
To prevent damage to a control system that uses an alternator or battery-
charging device, make sure the charging device is turned off before
disconnecting the battery from the system.
!
CAUTION
Electronic controls contain static-sensitive parts. Observe the following
precautions to prevent damage to these parts.
•
Discharge body static before handling the control (with power to the
control turned off, contact a grounded surface and maintain contact
while handling the control).
•
Avoid all plastic, vinyl, and styrofoam (except antistatic versions)
around printed circuit boards.
•
Do not touch the components or conductors on a printed circuit board
with your hands or with conductive devices.
Woodward Governor Company reserves the right to update any portion of this publication at any time. Information
provided by Woodward Governor Company is believed to be correct and reliable. However, no responsibility is
assumed by Woodward Governor Company unless otherwise expressly undertaken.
© 1999 by Woodward Governor Company
All Rights Reserved