WOPET FT50D - Hardware Installation; FAQs; How to Set Current Time; Food Dispensing Issues

ese >
fS
Rotate right on tank body and ® Rotate right to twist the ® Rotate left the lid and
take out the inside accessories lid and load in desiccant tank body to install back
Coy
<r
Assemble 2 trays in place and e Install the meal splitter and put
the bowls connector then insert into the stainless steel bowls
FAQs
Problem Solutions
1. Upon turning on, press the settings button to enter current time setup.
2. The clock will flash, adjust the hours using the up and down keys, and
How to set the current save by pressing the settings button.
ti 3. At this point, the minutes will flash, adjust the minutes using the up and
ime ; .
down keys, and again save by pressing the settings button.
4. When the numbers for hours and minutes are no longer flashing, the
current time setting is complete.
© Connect the power
hb
. Ensure the food's diameter is less than 12mm, only suitable for dry food.
. Check if the turntable is jammed, if so please clean it first.
3. Check if the food container still has food, please replenish in time if it's
Food did not dispense running low. 7
: 4. If it is battery-powered, please ensure there's sufficient battery power.
at the set time ;
We recommend using the plug and batteries at the same time.
5. For first-time use, please manually feed four times to ensure the food
fills the slot. Press the manual feeding button on the machine to feed.
N
How much is each | portions ~ 12g ~ 20mIl ~ 1/12cup ~ 4tsp ~ 4/3Tbsp
portion ? 20 portions at most per meal
How to cancel the
feeding plan for the Please set the number of feeding portions for the first meal to 0
first meal ?
Thank you for choosing WOPET pet feeder.
Please read the quick guide before using, If you have any problems when using our product,
kindly send email with order number to our mailbox: support@wopet.com for help,
we'll response within 24 hours.
Scan the QR code to set up the feeder